Owner's Manual

1. With the help of a second person, carefully lay the

treadmill on its side. Position one of the Base Legs

(55) on the base of the Upright (37) as shown. Make

sure that the Base Leg Pads (31) and the Wheel

(34) are in the indicated positions. Attach the Base

Leg with two of the four Base Leg Bolts (28), Base

Leg Washers (68), and Base Leg Nuts (61).

Carefully turn the treadmill onto its other side.

Assemble the other Base Leg (55) as described

above.

With the help of a second person, carefully raise the

treadmill to the upright position so the Base Legs

(55) are resting flat on the floor.

2. Hold the treadmill firmly with both hands, and lower

the treadmill to the floor.

To decrease the possibili-

ty of injury, bend your legs and keep your back

straight.

Cut the indicated plastic tie off the Left Handrail (39).

Position the Left Handrail (39) on the left Upright

(37). Loosely thread a Handrail Bolt (47) with a

asher (2) into the

upper end of the Left Handrail

and the left Upright. Next, loosely thread a Handrail

Bolt (47) with a W

asher (2) into the

lower end of the

Left Handrail and the left Upright. Do not tighten

the Handrail Bolts yet

ASSEMBLY

Assembly requires two people. Set all parts in a cleared area and remove the packing materials; do not dis-

pose of the packing materials until assembly is completed. Assembly requires the included allen wrench

s well as a phillips screwdriver and two adjustable spanners (not included).

Note: The underside of the walking belt is coated with high-performance lubricant. During shipping, a small amount

of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill

performance. If there is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-

abrasive cleaner.

If further assistance is needed, please call our Customer Service Department at 0345-089009.

Plastic Tie