Owner's Manual

4. Cut the plastic tie off the Right Handrail (41).
W
hilst a second person holds the Console Base (45)
and the Right Handrail (41) near the right Upright
(
37), insert the excess Wire Harness (53) through the
Right Handrail and down into the right Upright. Bend
the Wire Harness as shown, if necessary.
Next, make sure that the Wire Harness (53) is inside
of the bracket on the Right Handrail (41) and insert
the bracket into the right Upright (37). Make sure
that the Wire Harness is not pinched.
5. Loosely thread a Handrail Bolt (47) with a Washer (2)
into the
upper end of the Right Handrail (41) and the
right Upright (37). Next, loosely thread a Handrail
Bolt (47) with a Washer (2) into the
lower end of the
Right Handrail and the right Upright. Do not tighten
the Handrail Bolts yet.
6. Attach the Console Base (45) to the Handrails (39,
41) with four Console Base Screws (91).
Tighten the four Handrail Bolts (not shown) used
in steps 3 and 5.
The Console (49) requires three 1,5V batteries; alka-
line batteries are recommended. Open the Battery
Cover (48) and press the batteries into the Console;
the negative (–) ends of the batteries must touch
the springs. Close the battery cover, push up on the
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into
place.
7.
Attach the Left Frame Guide (66) and the Frame
Guide Spacer (46) to the left side of the Frame (21)
with four Latch Screws (25). Note: Be careful not
to overtighten the Latch Screws. Make sure that
the thick end of the Frame Guide is at the bottom.
7
6
21
66
46
Thick
end
25
4
41
53
37
P
lastic Tie
45
5
47
47
2
2
41
37
6
91
39
41
91
45
49
48
Battery Cover Tab
8. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet
from damage, place a mat under the treadmill.