Owner's Manual

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild dish soap. IMPORTANT: Keep liquids

away from the console and keep the console out of

direct sunlight. During storage, remove the batter-

ies from the console.

CONSOLE TROUBLESHOOTING

Most console problems are the result of low batteries.

See assembly step 12 on page 12 for replacement

instructions. If the handgrip heart rate monitor does not

function properly, see step 5 on page 16.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

See EXPLODED DRAWING B on page 23. Using a

flat screwdriver, release the tabs on the Lower Upright

Cover (83) and slide it upward.

Next, remove all of the screws from both shields. Then,

carefully remove the left shield.

Locate the Reed Switch (33). Loosen, but do not

remove, the M4 x 20mm Self-tapping Screw (45). Note:

For clarity, the left crank disc is shown removed in the

drawing below.

Next, rotate the Pulley (70) until a Magnet (78) is

aligned with the Reed Switch (33). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the M4 x 20mm Self-tapping Screw (45).

Rotate the Pulley for a moment.

Repeat these actions until the console displays correct

feedback. When the reed switch is correctly adjusted,

reattach the shields and the lower upright cover.

MAINTENANCE AND TROUBLESHOOTING