weslo.com Model No. WLCL99617.3 Serial No. Write the serial number in the space above for reference. Serial Number Decal ACTIVATE YOUR WARRANTY To register your product and activate your warranty today, go to my.weslo.com. CUSTOMER CARE For service at any time, go to wesloservice.com. Or call 1-866-699-3756 Mon.–Fri. 6 a.m.–6 p.m. MT Sat. 8 a.m.–12 p.m. MT Please do not contact the store. CAUTION Read all precautions and instructions in this manual before using this equipment.
TABLE OF CONTENTS WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 IMPORTANT PRECAUTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 BEFORE YOU BEGIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 PART IDENTIFICATION CHART.
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read all important precautions and instructions in this manual and all warnings on your stepper climber before using your stepper climber. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product. 1. It is the responsibility of the owner to ensure that all users of the stepper climber are adequately informed of all precautions. or carpet. Make sure that there is at least 2 ft.
STANDARD SERVICE PLANS 4
BEFORE YOU BEGIN Thank you for selecting the new WESLO® CLIMBER stepper climber. Stepping is one of the most effective exercises for increasing cardiovascular fitness, building endurance, and toning the entire body. The CLIMBER stepper climber provides a selection of features designed to make your workouts at home more effective and enjoyable. after reading this manual, please see the front cover of this manual. To help us assist you, note the product model number and serial number before contacting us.
PART IDENTIFICATION CHART Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra parts may be included.
ASSEMBLY • To hire an authorized service technician to assemble this product, call 1-800-445-2480. • To identify small parts, see page 6. • In addition to the included tool(s), assembly requires the following tools: • Assembly requires two persons. one adjustable wrench • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you complete all assembly steps. Assembly may be easier if you have a set of wrenches.
3. Attach the Rear Stabilizer (10) to the Frame (14) with two M8 x 32mm Carriage Bolts (9), two M8 Washers (7), and two M8 Acorn Nuts (6). 3 Attach the Front Stabilizer (8) to the Stand (24) in the same way. 24 6 14 7 6 8 7 10 9 9 4. Identify the Right Pedal (11), and attach it to the right side of the Frame (14) with two M6 x 20mm Screws (5). 4 Attach the Left Pedal (4) to the left side of the Frame (14) in the same way.
5. Using a plastic bag to keep your fingers clean, apply a generous amount of the included grease to the Frame Bushings (30) in the top of the Frame (14). 5 Grease 2 30 Next, identify the Right Handlebar (12). Insert the Right Handlebar into the right side of the Frame (14) as shown, and then attach it with an M8 x 25mm Screw (3). Then, tighten a Stop Screw (17) into the Right Handlebar (12). 30 14 12 Attach the Left Handlebar (2) to the left side of the Frame (14) in the same way. 17 3 6.
7. The Console (1) can use one AA battery (not included); an alkaline battery is recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before you insert a battery. Otherwise, you may damage the Console or other electronic components. 7 Avoid pinching the wires 1 C Remove the battery cover from the back of the Console (1), and insert a battery into the battery compartment.
HOW TO USE THE STEPPER CLIMBER HOW TO ADJUST THE HANDLEBARS HOW TO EXERCISE ON THE STEPPER CLIMBER To adjust the height of the handlebars, loosen the adjustment knob (A) on each handlebar, pull it outward, move the handlebar to the desired height, and then release the knob into one of the adjustment holes. Then, tighten each handlebar. Make sure to adjust both handlebars to the same height. Hold the grips or the handles and step onto the pedals.
FEATURES OF THE CONSOLE HOW TO OPERATE THE CONSOLE The console features five modes that provide instant exercise feedback during your workouts. The modes are described below. Note: If there is a sheet of plastic on the console, remove the plastic before operating the console. 1. To turn on the console, press the Mode button or simply begin stepping. When the console is turned on, the entire display will turn on for a few seconds. The console will then be ready for operation. 2.
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE CONSOLE TROUBLESHOOTING Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the stepper climber is used. Replace any worn parts immediately. Most console problems are the result of a low battery; for replacement instructions, see assembly step 7 on page 10. To clean the stepper climber, use a damp cloth and a small amount of mild soap.
EXERCISE GUIDELINES Aerobic Exercise—If your goal is to strengthen your cardiovascular system, you must perform aerobic exercise, which is activity that requires large amounts of oxygen for prolonged periods of time. For aerobic exercise, adjust the intensity of your exercise until your heart rate is near the highest number in your training zone. WARNING: Before beginning this or any exercise program, consult your physician.
PART LIST/EXPLODED DRAWING Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 Description Model No. WLCL99617.3 R0318A Key No. Qty.
ORDERING REPLACEMENT PARTS To order replacement parts, please see the front cover of this manual.
