Owners manual

7. The Console (1) can use one AA battery (not

included); an alkaline battery is recommended.

IMPORTANT: If the Console has been

exposed to cold temperatures, allow it to

warm to room temperature before you insert

a battery. Otherwise, you may damage the

Console or other electronic components.

Remove the battery cover from the back of the

Console (1), and insert a battery into the battery

compartment. Make sure to orient the battery

as shown by the diagram inside the battery

compartment. Then, reattach the battery cover.

Next, hold the Console (1) near the Frame (14),

and connect the wire (C) on the Console to the

Reed Switch Wire (20) in the Frame (14).

Tip: Avoid pinching the wires. Slide the

Console (1) onto the clip (D) on the Frame (14).

8. Make sure that all parts are properly tightened before you use the stepper climber. After the stepper

climber is assembled, inspect it to make sure that it is assembled correctly and that it functions prop-

erly. Extra parts may be included. Place a mat under the stepper climber to protect the floor or carpet from

damage.

Avoid pinching

the wires