Owner's Manual

6. Identify the Left Handlebar (6), which is marked with a

“Left” sticker. Insert the Left Handlebar into one of the

Handlebar Arms (5); make sure that the Handlebar

Arm is turned so the hexagonal holes are on the

indicated side. Attach the Left Handlebar with two M6

x 38mm Button Bolts (50) and two M6 Nylon Locknuts

(27). Make sure that the Nylon Locknuts are inside

the hexagonal holes. Do not fully tighten the Button

Bolts yet.

Apply a small amount of the included grease to the left

axle on the Upright (2).

Make sure that there are two Small Handlebar

Bushings (49) in the Left Handlebar (6). Slide a

Handlebar Spacer (47) and the Left Handlebar onto the

left axle on the Upright (2) as shown. Make sure that the

Handlebar Spacer is turned so the curved side is fac-

ing the Upright. Then, tap an Axle Cap (14) onto the

axle.

Repeat this step to assemble the Right Handlebar (8)

and the other Handlebar Arm (5).

Grease

7. Identify the Left Pedal Arm (11), which is marked with a

“Left” sticker. Attach a Pedal (13) to the Left Pedal Arm

with two M6 x 45mm Flat Head Screws (36).

Attach the other Pedal (not shown) to the Right Pedal

Arm (not shown) in the same way.

Hexagonal

Holes