Owner's Manual

8
9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip-
tical exerciser.
8. Apply grease to the axle on the left Disc
Crossbar (16) and to a Pedal Arm Bolt Set (40).
Slide the Left Pedal Arm (11) and a Wave
Washer (64) onto the axle on the left Disc
Crossbar (16). Next, slide an M10 Washer (35)
onto an M10 x 25mm Patch Screw (22), and
tighten the Patch Screw into the axle.
Hold the left Handlebar Arm (5) inside the brack-
et on the Left Pedal Arm (11). Attach the
Handlebar Arm to the Left Pedal Arm with the
Pedal Arm Bolt Set (40). Do not overtighten
the Pedal Arm Bolt Set; the Handlebar Arm
must pivot freely.
Repeat this step on the other side of the
elliptical exerciser.
See step 5. Tighten the M10 x 68mm Button
Bolts (48).
See step 6. Tighten the M6 x 38mm Button
Bolts (50).
Grease
Grease
22
35
11
5
8
16
40
40
64
7
3
6
11
1
3
7. Identify the Left Pedal Arm (11), which is marked
with a sticker.
O
rient the Left Pedal Arm (11) and a Pedal (13)
as shown. Attach the Pedal to the Left Pedal
A
rm with two M6 x 45mm Flat Head Screws
(36).
Attach the other Pedal (not shown) to the
Right Pedal Arm (not shown) in the same
way.