Owner's Manual

6. While another person holds the Console (5) near the

Console Bracket (26), connect the wires on the

Console to the Upper Wire Harness (79) and the

Pulse Wire Harness (80). Insert the Wire Harnesses

down into the Upright (2).

Attach the Console (5) to the Console Bracket (26)

with four M4 x 16mm Screws (66).

Be careful to

avoid pinching the wire harnesses.

Attach the Water Bottle Holder (63) to the Upright (2)

with two M4 x 19mm Screws (39).

Console

Wires

Batteries

Battery

Cover

7. The Console (5) requires four “D” batteries (not

included); alkaline batteries are recommended. Look

under the Console and locate the battery cover.

(Note: The drawing shows the Console removed for

clarity.) Press the tab on the battery cover and

remove it. Insert four batteries into the console,

mak-

ing sure that the batteries are oriented as shown

by the diagram inside the Console. Reattach the

battery cover to the Console.

5. Hold the Console Bracket (26) near the Upright (2),

and locate the wire extending from the bottom of the

Console Bracket. Carefully pull the upper end of the

Upper Wire Harness (79) to remove any slack, and tie

the wire around the Upper W

ire Harness, as shown in

the inset drawing. Carefully pull the wire up through

the Console Bracket until the Upper Wire Harness is

extending from the top of the Console Bracket. Then,

untie the wire and discard it.

Insert the Console Bracket (26) into the Upright (2).

Be careful to avoid pinching the Upper Wire

Harness (79).

Attach the Console Bracket with three

M8 x 25mm Button Screws (57) and three M8 Split

Washers (74).

ire