Owner's Manual
7
9
10
82
82
38
2
20
Grease
Tube
13
14
10
26
9. Insert the Pivot Axle (38) through the Upright (2). Apply
a generous amount of the included grease to the Pivot
Axle.
Identify the Left and Right Handlebars (9, 10), which
are marked with stickers. Have another person hold
the Left Handlebar near the left end of the Pivot Axle
(38). Insert the left Pulse Sensor Wire (71) through a
Handlebar Spacer (25).
Make sure that the
Handlebar Spacer is oriented as shown, with the
small cutout on top. Slide the Handlebar Spacer onto
the short tube on the Left Handlebar.
Connect the Pulse Sensor Wire (71) to the Pulse Wire
Harness (80), and insert the Pulse Sensor Wire and
the Pulse Wire Harness into the opening in the side of
the Console Bracket (26). Slide the Left Handlebar (9)
onto the Pivot Axle (38).
Be careful to avoid pinching
the wires. Assemble the Right Handlebar (10) in the
same way
.
T
ighten an M8 x 19mm Button Screw (22) with an M8
Large W
asher (17) into each end of the Pivot
Axle (38).
Orient the two Handlebar Caps (23) as shown, and
press the small tabs on the Handlebar Caps into the
two Handlebar Spacers (25).
Gently seperate the two Upright Covers (82). Hold the
Upright Covers around the Upright (2),
and firmly
press the Upright Covers together.
10. Identify the Left Pedal (13), which has an “L” molded
into its bottom surface, and the Left Pedal
Arm (14),
which is marked with a sticker.
Attach the Left Pedal (13) to the Left Pedal
Arm (14)
with two M8 x 46mm Button Screws (20).
Attach the Right Pedal (not shown) in the same way.
23
23
Tab
22
22
17
17
25
71
9
80
25
8
9
73
46
Tube
Hexagonal
Holes
50
8. Identify the Left Handlebar (9) and the Left Handlebar
Leg (73), which are marked with stickers.
Insert the Left Handlebar (9) into the Left Handlebar
Leg (73).
Make sure that the short tube on the Left
Handlebar and the hexagonal holes in the Left
Handlebar Leg are on the same side. Attach the
Left Handlebar with two M8 x 42mm Button Bolts (50)
and two M8 Nylon Locknuts (46). Do not tighten the
Button Bolts yet.
Attach the Right Handlebar (not shown) to the Right
Handlebar Leg (not shown) in the same way.