Owner's Manual

5. Apply a small amount of the included grease to a

Wave Washer (27) and slide it onto one end of the

Pivot Axle (16). Next, slide an M8 Washer (64) and a

Pivot Cover (14) onto an M8 x 23mm Button Screw

(65), and tighten the Button Screw into the Pivot Axle.

Apply a generous amount of grease to the Pivot Axle

(16). Identify the Left and Right Upper Body Legs (6,

7), which are marked with “Left” and “Right” stickers.

While another person aligns the Left and Right Upper

Body Legs with the Upright (2) as shown, insert the

Pivot Axle into the Upper Body Legs and the Upright.

Be careful not to damage the Upper Wire Harness

(18) with the Pivot Axle.

Apply a small amount of grease to a Wave Washer

(27), and place it on the end of the Pivot Axle (16).

Next, slide an M8 Washer (64) and a Pivot Cover (14)

onto an M8 x 23mm Button Screw (65), and tighten

the Shoulder Screw into the Pivot Axle. Make sure

that the Wave Washer remains on the end of the

Pivot Axle.

6. Apply a generous amount of grease to the axle on

the Left Upper Body Leg (6). Then, apply grease to a

Large Wave Washer (20) and slide it onto the axle.

Apply a generous amount of grease to the Left

Crank Arm (42). Orient a Crank Arm Spacer (45) so

the flat side is facing away from the Left Crank Arm,

and slide the Crank Arm Spacer onto the Left Crank

Arm.

Slide the Left Pedal Arm (21) onto the Left Upper

Body Leg (6) and the Left Crank Arm (42).

Repeat this step for the other side of the elliptical

exerciser.

Grease

7. Attach the Left Pedal Arm (21) to the Left Upper Body

Arm (6) with an M8 x 23mm Button Screw (65), an

M8 Washer (64), and a Pedal Leg Cover (23).

Apply grease to a Large Wave Washer (20) and

slide it onto the Left Crank Arm (42). Then, attach the

Left Pedal Arm (21) to the Left Crank Arm with an

M8 x 25mm Patch Screw (70) and an M8 Large

Washer (81).

See step 3. Tighten the four M8 x 19mm Patch

Screws (73).

Grease