Owner's Manual

7
4. While another person holds the Console (23)
n
ear the Upright (2), connect the console wire to
the Upper Wire (44). Then, insert the console
wire and the Upper Wire into the Upright.
Tip: Avoid pinching the wires. Attach the
Console (23) to the Upright (2) with four M4 x
1
6mm Screws (42).
Turn the Resistance Knob (63) counterclock-
wise to the lowest setting before going to
the next step.
4
23
2
44
63
C
onsole Wire
42
5
1
2
33
Avoid pinching the
wires and cables
during this step
Avoid pinching
the wires during
this step
44
53
48
55
45
59
5. While another person holds the Upright (2) near
the Frame (1), connect the Upper Wire (44) to
the Reed Switch Wire (53).
Next, connect the Resistance Cable (45) to the
Lower Cable (55) in the following way:
• See drawing A. Pull upward on the metal
bracket on the Lower Cable (55), and insert
the tip of the Resistance Cable (45) into the
wire clip inside of the metal bracket.
• See drawing B. Firmly pull the Resistance
Cable (45) and slide it into the metal bracket
on the Lower Cable (55) as shown.
• See drawing C. Using pliers, squeeze
together the prongs on the upper end of the
metal bracket.
Tip: Avoid pinching the wires and cables.
Push the excess cable and wire downward into
the Frame (1). Next, slide the Upright (2) onto
the Frame.
Attach the Upright (2) with two M10 x 68mm
Button Bolts (48), two M10 Split Washers (59),
and two M10 Locknuts (33). Do not tighten the
Button Bolts yet.
55
55
Metal
Bracket
B
A
C
55
45
45
45