Owner's Manual

8
50
8
27
6. Identify the Left Handlebar (6), which is marked
with a “Left” sticker.
Insert the Left Handlebar (6) into one of the
Upper Body Arms (5); make sure that the
h
exagonal holes are in the indicated
location.
Attach the Left Handlebar (6) to the Upper Body
Arm (5) with two M6 x 38mm Button Bolts (50)
and two M6 Locknuts (27). Make sure that the
Locknuts are inside the hexagonal holes. Do
not fully tighten the Button Bolts yet.
Apply a small amount of the included grease to
the left axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar
onto the left axle on the Upright (2) as shown.
Make sure that the Handlebar Spacer is
turned so the curved side is facing the
Upright. Tap an Axle Cap (14) onto the axle.
Repeat this step for the Right Handlebar (8)
and the other Upper Body Arm (5).
Grease
6
47
14
49
5
2
5
6
7
36
11
13
7. Identify the Left Pedal Arm (11), which is
marked with a “Left” sticker.
Attach a Pedal (13) to the Left Pedal Arm (11)
with two M6 x 45mm Flat Head Screws (36).
Attach the other Pedal to the Right Pedal
Arm (not shown) in the same way.
Hexagonal
Holes