Owner's Manual

9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

8. Apply a small amount of grease to the axle on

the left Disc Crossbar (16). Slide the Left Pedal

rm (11) onto the axle, and then slide a Wave

Washer (64) on the end of the axle.

Next, tighten an M10 x 25mm Patch Screw (22)

and an M10 Washer (35) into the axle.

old the lower end of the left Upper Body Arm

(5) inside the bracket on the Left Pedal Arm

(11). Next, apply grease to a Pedal Arm Bolt Set

(40). Attach the Left Pedal Arm to the left Upper

Body Arm with the Bolt Set. Do not overtighten

the Bolt Set; the Upper Body Arm must pivot

freely.

Attach the Right Pedal Arm (not shown) to

the right side of the elliptical exerciser in the

same way.

See step 5. Tighten the M10 x 68mm Button

Bolts (48).

See step 6. Tighten the M6 x 38mm Button

Bolts (50) in the Upper Body Arms (5).

rease

Grease