Owner's Manual

8
50
8
27
7. Identify the Left Handlebar (6), which is marked
with a “Left” sticker. Insert the Left Handlebar
into one of the Upper Body Arms (5); make
sure that the hexagonal holes are on the indi-
cated side.
Attach the Left Handlebar (6) to the Upper Body
Arm (5) with two M6 x 38mm Button Bolts (50)
and two M6 Locknuts (27). Make sure that the
Locknuts are in the hexagonal holes. Do not
fully tighten the Button Bolts yet.
Apply a small amount of the included grease to
the left axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar
onto the left axle on the Upright (2) as shown.
Make sure that the curved side of the
Handlebar Spacer is facing the Upright. Then,
tap an Axle Cap (14) onto the axle.
Repeat this step with the Right Handlebar (8)
and the other Upper Body Arm (5).
Grease
7
47
14
49
5
2
5
6
Hexagonal
Holes
6
2
42
65
6. Attach the Water Bottle Holder (65) to the
Upright (2) with two M4 x 16mm Screws (42).