Owner's Manual

9
10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
9. Apply a small amount of grease to the axle on
the left Disc Crossbar (16). Slide the Left Pedal
Arm (11) onto the axle, and then slide a Wave
Washer (64) on the end of the axle.
Next, tighten an M10 x 25mm Patch Screw (22)
and an M10 Washer (35) into the axle.
Apply grease to a Pedal Arm Bolt Set (40).
Hold the lower end of the left Upper Body Arm
(5) inside the bracket on the Left Pedal Arm
(11). Attach the Left Pedal Arm to the left Upper
Body Arm with the Pedal Arm Bolt Set (40). Do
not overtighten the Bolt Set; the Upper Body
Arm must pivot freely.
Attach the Right Pedal Arm (not shown) to
the right side of the elliptical exerciser in the
same way.
See step 5. Tighten the M10 x 68mm Button
Bolts (48).
See step 7. Tighten the M6 x 38mm Button
Bolts (50) in the Upper Body Arms (5).
Grease
Grease
22
35
11
5
9
16
40
40
64
8
3
6
11
13
8. Identify the Left Pedal Arm (11), which is
marked with a “Left” sticker.
A
ttach a Pedal (13) to the Left Pedal Arm (11)
with two M6 x 45mm Flat Head Screws (36).
Attach the other Pedal to the Right Pedal
Arm (not shown) in the same way.