® Sears Model No. 831,21600.0 Kmart Model No. WLEX1076.0 USER'S MANUAL Serial No, Write the serial number in the space above for future reference. Serial Number Decal QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT DIRECTLY. \ SEARS CUSTOMERS: 1-800-4-MY-HOME ® (1-800-469-4663) KMART CUSTOMERS: 1-866-699-3756 Mon.-Fri., 6 a.m.-6 p.m. MST www.wesIo.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS .... BEFORE YOU BEGIN .... ASSEMBLY .... HOW TO OPERATE THE EXERCISE CYCLE MAINTENANCE AND TROUBLESHOOTING CONDITIONING GUIDELINES PART LIST ...... EXPLODED DRAWING .... ORDERING REPLACEMENT PARTS .. LIMITED WARRANTY .... •• 2 3 4 8 10 11 14 • 15 Back Cover Back Cover IMPORTANT PRECAUTIONS &WAR NING: To reduce the risk of serious injury, read the following important precau- tions before using the exercise cycle. 1.
BEFORE YOU BEGIN Congratulations for selecting the new WESLO ® PURSUIT 350 exercise cycle. Cycling is one of the most effective exercises for increasing cardiovascular fitness, building endurance, and toning the body. The PURSUIT 350 exercise cycle offers a selection of features designed to let you enjoy this healthful exercise in the convenience and privacy of your home. after reading this manual, please see the front cover of this manual.
ASSEMBLY Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable wrench _, Phillips screwdriver _ _, and pliers _. Use the drawings below to identify the small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14.
3. Attachthe LeftandRightUprightCovers(14,15) aroundtheFrame(1)withthreeM4x 25mmRound HeadScrews(41)asshown. 15 4. AttachtheSeat(12)to theSeatPost(5)withfour M8SplitWashers(42)andfourM8Nylon Locknuts(10).Note:TheSplitWashersandthe Nylon Locknuts may be pre-attached to the underside of the Seat, 10 5. Turn the Seat Knob (9) counterclockwise and remove it from the Frame (1). Next, insert the Seat Post (5) into the Frame.
. WhileanotherpersonholdstheUpright(13)near the Frame(1)asshown,connectthe Extension Wire (23)to theReedSwitchWire(39).Next,connectthe Resistance Cable(19)totheLowerCable(29)inthe followingway: • SeedrawingA. Pullupon themetalbracketon theLowerCable(29),andinsertthetipof the Resistance Cable(19)intothewireclipinsideof themetalbracketasshown. Be careful to avoid pinching the wires and cables. • SeedrawingB. FirmlypulltheResistance Cable(19)upwardandslideit intothetopofthe metalbracketasshown.
8. While a second person holds the Console (16) near the Upright (13), connect the console wire to the Extension Wire (23). Then, insert the wires downward into the Upright. 16 Attach the Console (16) to the Upright (13) with four M6 x 15mm Button Screws (46). Be careful to avoid pinching the wires. 23 Console Wire 46 Be careful to avoid pinching the wires. 9. Identify the Left Pedal (24), which is marked with a "Left" sticker.
HOW TO OPERATE THE EXERCISE CYCLE HOW TO ADJUST THE SEAT POST FEATURES OF THE CONSOLE For effective exercise, the seat should be at the proper height. As Seat you pedal, there should be a slight bend in your knees Seat Post when the pedals are in the lowest position. To adjust Hole\ the height of the seat, first turn the Seat Knob seat knob counterclockwise and remove it.
HOWTOUSE THE CONSOLE Note: The console can show speed and distance in either miles or kilometers, The letters Before using the console, make sure that batteries are installed (see assembly step 7 on page 6). If there is a sheet of clear plastic on the display, remove the plastic. "mph" or "km/h" will appear in the display to show which unit of measurement is selected.
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield, the upright covers, and the left pedal. To clean the exercise cycle, use a damp cloth and a small amount of mild detergent.
CONDITIONING GUIDELINES The following guidelines will help you to plan your exercise program. Remember that proper nutrition and adequate rest are essential for successful results. During the first few minutes of exercise, your body uses easily accessible carbohydrate calories for energy. Only after the first few minutes of exercise does your body begin to use stored fat calories for energy.
SUGGESTED STRETCHES The correct form for several basic stretches is shown at the right. Move slowly as you stretch--never bounce. 1. Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible. Hold for 15 counts, then relax. Repeat 3 times. Stretches: Hamstrings, back of knees and back. 2. Hamstring Stretch Sit with one leg extended.
NOTES 13
PART LIST Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 1 1 2 2 1 1 2 2 1 4 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 SEARS MODEL NO. 831.21600.0; KMART MODEL NO. WLEX1076.0 Description Key No. Qty.
EXPLODED DRAWING SEARS MODEL NO. 831.21600.0; KMART MODEL NO. WLEX1076.
ORDERING REPLACEMENT PARTS To order replacement parts, please see the front cover of this manual. To help us assist you, be prepared to provide the following information when contacting us: • the MODEL NUMBER of the product (Sears Model No. 831.21600.0; Kmart Model No. WLEX1076.