Owner's Manual

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Per FCC rules, changes or modifications not expressly approved by ICON could void the

user's authority to operate the equipment.

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

ven when the resistance is at the highest level, the

drive belt may need to be adjusted.

To adjust the drive belt, you must first remove the right

pedal and the right shield as described below.

Using an adjustable wrench, turn the right pedal coun-

terclockwise and remove it. Next, remove all the

screws from the left and right shields; there are two

sizes of screws in the shields–note which size of

screw you remove from each hole. Then, gently pull

the right shield away from the frame.

Loosen the Flywheel Axle (39). Next, tighten the M6

Locknuts (63), one on each side of the Flywheel (37),

until the Drive Belt (35) is tight. Then, tighten the

Flywheel Axle.

Reattach the right shield and the right pedal.