Owner's Manual

9
11
16
Screw
10. Attach the Handlebar (53) to the Upright (13)
with two M8 x 65mm Button Bolts (36), two M8
Curved Washers (46), and two M8 Locknuts
(10).
10
36
53
10
46
13
Batteries
Battery Cover
11. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the screw, remove the battery
cover, and insert the batteries into the battery
compartment. Make sure to orient the batter-
ies as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
9. Insert the excess wire and cable downward into
the Frame (1).
Tip: Avoid pinching the wires. Insert the
Upright (13) into the Frame (1).
Attach the Upright (13) with three M8 x 20mm
B
utton Screws (34) and three M8 Split Washers
(42).
9
Avoid pinching
the wires
1
1
3
34
34
42
42