Instructions / Assembly

11
9
9. Tip: Avoid damaging the Upright Wire (36).
Attach the Handlebar (46) to the Upright (35)
with two M8 x 65mm Bolts (16), two M8 Curved
Washers (17), and two M8 Acorn Nuts (42); start
both Bolts, and then tighten them.
Avoid damaging the
Upright Wire (36)
8
8. Connect the Resistance Cable (37) to the Lower
Resistance Cable (34) in the following way:
See drawing A. Pull upward on the metal
bracket (A) on the Lower Resistance Cable (34),
and insert the tip of the Resistance Cable (37)
into the wire clip inside the metal bracket.
See drawing B. Firmly pull the Resistance
Cable (37) upward and slide it into the top of the
metal bracket (A).
See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Then, attach the Resistance Control (37) to the
Upright (35) with an M5 x 14mm Screw (38).
Avoid pinching
the cable
A
B
C
34
37
37
A
A
A
35
35
36
16
46
42
17
34
38
37