Instructions / Assembly

MAINTENANCE

Inspect and tighten all parts of the exercise bike

regularly. Replace any worn parts immediately.

To c l ean the e xerc ise b ike , use a d a mp c loth and a

small amount of mild detergent. IMPORTANT: To

avoid damage to the console, keep liquids away

from the console and keep the console out of

direct sunlight.

CONSOLE TROUBLESHOOTING

If the console display becomes dim, replace the bat-

teries (see assembly step 11 on page 12); most

console problems are the result of low batteries.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To a d just the reed swi t ch, firs t tu r n th e re s ist a nce knob

to the lowest setting.

Next, using an adjustable wrench, turn the left pedal

clockwise and remove it.

Then, see the EXPLODED DRAWING on page 23.

Remove the M4 x 50mm Screws (31) and the 3/16" x

3/4" Screws (32) from the Left and Right Shields (29,

30); note which size of Screw you remove from

each hole. Then, gently remove the Left Shield.

Locate the Reed Switch (7). Turn the Crank (3) until a

Magnet (12) is aligned with the Reed Switch.

Next, loosen, but do not remove, the two M4 x 10mm

Screws (25). Slide the Reed Switch (7) slightly closer

to or away from the Magnet (12). Then, retighten the

two Screws. Turn the Crank (3) for a moment.

Repeat these actions until the console displays correct

feedback. When the reed switch is correctly adjusted,

reattach the left shield and the left pedal.

MAINTENANCE AND TROUBLESHOOTING