Instructions / Assembly

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is at the highest level, the

drive belt may need to be adjusted.

To adjust the drive belt, you must first remove the right

pedal and the right shield as described below.

Using an adjustable wrench, turn the right pedal

counterclockwise and remove it.

Next, see the EXPLODED DRAWING on page 23.

Remove the M4 x 50mm Screws (31) and the 3/16" x

3/4" Screws (32) from the Left and Right Shields (29,

30); note which size of Screw you remove from

each hole. Then, gently remove the Right Shield.

Loosen the two M8 Locknuts (9) on the two M8 Idler

Bolts (19). Then, tighten the M10 x 35mm Screw (20)

until the Drive Belt (5) is tight. When the Drive Belt is

tight, tighten the two Locknuts.

Then, reattach the right shield and the right pedal.