Owner's Manual

10. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is

completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.

8. Orient the Seat Bushing (8) so that the indicated

hole in the Seat Bushing is aligned with the indi-

cated hole in the Frame (1).

Press the Seat Bushing (8) into the Frame.

ttach the Seat Bushing with two M4 x 5mm

Screws (14).

Insert the Seat Post (5) into the Frame (1), and

align one of the adjustment holes in the Seat

Post with the hole in the Frame.

Next, insert the Seat Knob (9) through the

Frame (1) and the Seat Post (15), and then

tighten the Seat Knob. Make sure that the Seat

Knob is inserted through one of the adjust-

ment holes in the Seat Post.

Hole

Adjustment

Holes

9. Identify the Left Pedal (24), which is marked

with an “L.”

Using an adjustable wrench, firmly tighten the

Left Pedal (24) counterclockwise into the left

arm of the Crank (21). Tighten the Right Pedal

(not shown) clockwise into the right arm of the

Crank. IMPORTANT: Tighten both Pedals as

firmly as possible. After using the exercise

cycle for one week, retighten the Pedals. For

best performance, keep the Pedals tightened.

Adjust the strap on the Left Pedal (24) to the

desired position, and press the end of the strap

onto the tab on the Left Pedal. Adjust the

strap on the Right Pedal (not shown) in the

same way.

Strap

Tab