Manualshelf

Owner's Manual

ManualsBrandsWeslo ManualsHome GymsWeslo WLTL01531
12345678910
4
ASSEMBLY
The help of a second person is recommended. Set the treadmill in a cleared area and remove all packing
materials. Do not dispose of the packing materials until assembly is completed. Assembly requires only the
included allen wrench and wrench .
38
13
13
37
37
38
Hole
Holes
H
oles
1
1. Identify the Right Upright (36), which has a single hole in
the indicated location. (Note: There is a wire inside of
the Left Upright [35].) Hold the Right Upright against the
Base (14) as shown, and orient the Right Upright so the
two indicated holes are on the side shown.
Attach the Right Upright (36) to the Base (14) with two
M8 x 50mm Bolts (38), two M8 Curved Washers (37),
and two M8 Nylon Nuts (13) as shown. Make sure that
the curved sides of the Washers are against the Base.
Do not tighten the Nylon Nuts yet.
Attach the Left Upright (35) to the Base (14) in the same
way. Make sure that the Left Upright is oriented so the
two indicated holes are on the side shown.
Do not tight-
en the Nylon Nuts yet.
3. Attach the Hood (28) to the front of the Frame (29) with
two M5 x 10mm Bolts (10).
3
10
10
28
29
2. Raise the Left Upright (35) and the Right Upright (36) to
the position shown.
2
35
36
36
35
14
37
37
4a
4. See drawing 4a. Hold the front of the Frame (29)
between the Left Upright (35) and the Right Upright (not
shown). Align the holes near the front of the Frame with
one of the three sets of adjustment holes in the Uprights.
Insert the two
Adjustment Pins (4) into the holes in the
Upright and the Frame. Make sure that the Adjustment
Pins are fully inserted at the same height.
Look under the Frame (29) near the Left Upright (35).
See drawing 4b. Locate the Clip (11) attached to the
underside of the Frame. Insert the Reed Switch (6) into
the Clip as shown. Next, locate the Magnet (12) on the
left Flywheel (9). Turn the Flywheel until the Magnet is
aligned with the Reed Switch. Move the Reed Switch
so that there is a 1/8” gap between the Reed Switch
and the Magnet.
Then, tighten the M4 x 12mm Screw
(45) in the Clip.
4
29
12
9
45
1
1
6
1/8”
View from
below
35
4b
29