Owner's Manual

3. Hold the Console Base (87) near the right Handrail (4).

Make a loop with the indicated plastic tie and insert the

two Wires (53) through the loop. Pull only enough Wire

to connect the Wires to the two connectors in the

Console Base (87). Important: Make sure that the

Wires are fully inserted. WARNING: Do not discon-

nect or connect the Wires while the treadmill power

cord is plugged in.

Refer drawing 3a. Set the Console Base (87) on the

Handrails (4). Thread four Console Screws (3) into the

Handrails and the Console Base. After all four Screws

have been started, tighten the Screws until they are

snug; do not overtighten the Screws.

Feed the excess Wire Harness (53) into the upper end

of the right Handrail (4). Pull the plastic tie tight and cut

off the end.

4. Attach the Storage Latch (16) to the left Upright (38)

with two Latch Screws (14). Be careful not to over-

tighten the Screws.

Refer to step 2. Tighten the four Handrail Bolts (1).

4. Loosley thread the bottom two Weight Rack Screws (13)

into the Upright (38). Loosley thread the other four

Screws before going back and tightening all the Screws.

Set a 3-lb. Weight (not shown) on the bottom hanger on

the Weight Rack (15), a 2-lb. Weight on the middle

hanger, and a 1-lb. Weight on the top hanger.

Attach the other Weight Rack and Weights (not shown)

to the left Upright in the same way.

6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a

mat under the treadmill.

Hanger

Plastic

Tie

Plastic

Tie