Manual

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials, Do not

dispose of the packing materials until assembly is completed, Note: The underside of the treadmill walking belt is

coated with high-performance lubricant, During shipping, a small amount of lubricant may be transferred to the

top of the walking belt or the shipping carton, This is a normal condition and does not affect treadmill perfor-

mance, if there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,

non-abrasive cleaner,

Assembty requires the incJuded allen wr_ and your own phiJJips screwdriver

wire cutters -_<,_z>, rubber mallet _, and adjustable wrench

For help identifying the assembly hardware, refer to the drawings below, Note: The assembly hardware and other

small parts are packaged in separate part bags, Do not open the part bags untiJ instructed to do so. (The

part bags are not JabeJedaccording to the order in which they are to be opened.} If a part is not found in

the part bags, check to see if the part has been preassembted.

3/4" Screw (6)-16

<szsq}@

1 1/4" Screw (92)-2

2" Silver Screw (93)-2

1 1/4" Bolt (104)-4

1" Bolt (71)-2

Wheel Nut (21)-2

Wheel Bolt (107)-2

Internal Star

Washer (72)-4

5/16" Star

Washer (127)-2

1, Open part bag B. identify the Right Upright (82) (the

Left Upright [69] has a large round hob in the location

shown), Lay the Right Upright fiat, Cut the plastic ties off

the lower end of the Right Upright, Next, feed the Wire

Harness (83) into the bottom of the Right Upright and

pull it out of the hob in the top, Note: There may be a tie

on the end of the Wire Harness to help you pull it

through the hob,

Attach the Right Upright (82) to the bracket on the right

side of the Base (109) with two 1 1/4" Bolts (104) and

two Internal Star Washers (72), (Note: it may be helpful

to use a rubber mallet to fully insert the Right Upright

into the bracket,) Do not tighten the BoJts yet. Be

carefut not to damage the Wire Harness.

Attach the Left Upright (69} to the teft side of the

Base (109} in the same way. Note: There is not a wire

harness on the left side,

Hole

109