Manual

HoHdthePuHseBar(125)neartheConsoHeBase(85),

ConnectthePuHseWire(124)onthePuHseBartotheino

dicatedwireontheConsoHeBase,Theconnectors

shouJdsJidetogethereasily and snap into place. Hf

the connectors do not slide together easily and snap into

pHace, turn one connector and try to connect them again,

Hnsertthe wires into the hoHein the ConsoHe Base,

Have a second person hoHdthe PuHseBar (125) firmHyon

the ConsoHe Base (85), Attach the PuHseBar to the

ConsoHe Base with two ! 1/4" Screws (92) in the loca-

tions shown. Be careful not to damage the Pulse

Wire (!24} or the wire on the ConsoJe Base. Next,

tighten two 2" SHver Screws (93) into the ConsoHe Base

and the PuHseBar in the Hocations shown, Note: The

correct Screws must be used in the correct loca-

tions, or the Pulse Bar may be damaged.

125

Hdentifythe Left and Right HandraiHs (68, 81) (see the

end views of the HandraiHs in the inset drawing), The

curved edges of the HandraiHs shouHdbe on the outside,

SHidethe Right HandraiH(81) onto the Right HandraiH

Bracket (113), and press the Hipon the front of the Right

HandraiH under the ConsoHe Base (85), (Note: Htmay be

heHpfuHto tip the Right HandraiH and to tap it with a rub-

ber maHHetto correctly position it,) Tighten three 3/4"

Screws (6) into the Right HandraiH as shown, Note: Ht

may be necessary to move the Howerend of the Right

HandraiHsHightHyto aHignthe Howerscrew hoHe,

Attach the Left Handrait (68} in the same way.

See assembly step 1. Tighten the four 1 1/4" Bolts

(104).

-Curved Edge

(81) (68)

Press the Latch Knob SHeeve(75) into the Left Upright

(69), Note: Htmay be heHpfuHto use a rubber maHHetto

fuHHyinsert the Latch Knob SHeeve,

Remove the Latch Knob (70) from the Latch Pin (80).

Make sure that the Latch Pin CoHHar(76) and the Spring

(77) are on the Latch Pin. (Note: Hfthere are two Latch

Pin CoHHars,pHaceone on each side of the Spring.) Hnsert

the Latch Pin into the Left Upright (69) and tighten the

Latch Knob onto the Latch Pin,

Make sure that aH parts are properJy tightened before you use the treadmill. Note: Extra hardware may

be incHuded, Keep the incHuded aHHenwrenches in a secure pHace,The HargeaHHenwrench is used to adjust the

waHking beHt(see page 23), To protect the floor or carpet, pHacea mat under the treadmiHL