Instruction Manual

III-7.9 REZEPT ( recipe management (No. 37))
The function has 5 groups (recipe blocks) each with 4 memory locations. The recipes can be written via parameter set
-
ting and analog inputs. The function parameters are stored in EEPROM with back-up.
Selection which recipe block is output at y1...y4 is determined by the value applied to input SetNo.
In mode STORE (store = 1), the values applied to x1... x4 are written into the memory addresses of the recipe block
selected with input SetNo.
During manual mode (manual = 1), the inputs are directly connected with the outputs.
If more than 5 recipes are required, a corresponding number of recipe functions are simply cascaded.
a
Values of the used analog inputs are stored as parameter values when detecting a positive edge at the
store- input. This input should be activated only with relevant changes of the input values. Too frequent
storing operations may lead to the destruction of the EEPROM! (r page 311)
With cascading, the values for the overall recipe are available at outputs y1...y4 of the last stage.
Selecting and storage 9499-040-82711
III-141 REZEPT ( recipe management (No. 37))
y1
y2
y3
y4
x1
x2
x3
x4
-5
manual
store
SetNo Casc
Set1.1
Set1.2
Set1.3
Set1.4
1
Set2.1
Set2.2
Set2.3
Set2.4
2
Set3.1
Set3.2
Set3.3
Set3.4
3
Set4.1
Set4.2
Set4.3
Set4.4
4
Set5.1
Set5.2
Set5.3
Set5.4
5
Example for 15 recipes