Assembly Instruction

apex tower

assembly instructions

Page 6 of 69756131/9756149- 01/13/09

5. Once you have double checked your measurements you will need to screw a wall anchor (3) into the

center of both marks. Screw clockwise until the anchor is  ush with the wall surface. Next insert a

screw (4) and tighten until about 1/2” sticks out of the wall. Place tower back into position aligning

screws with the holes in the back of the top rail. Left and press tower onto screws. Slide down to lock

onto screws. Note: If ladder is not tight against wall, you may have to remove ladder and adjust screws .

CARE INSTRUCTIONS

Hardware may loosen overtime. Periodically check that all connections are tight.

Wipe with a soft, dry cloth. To protect  nish, avoid the use of chemicals and household cleaners.

Adjustable levelers are installed in the legs to

accommodate uneven  ooring. To adjust these levelers,

simply turn them counterclosckwise to raise the leg.

1/2” inch