Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Coconut Strips Pendant

assembly instructions

coconut strips pendant

Important Safety Instructions:

·Joist mounting is recommended. Use proper hardware for your ceiling type. When in doubt consult your local hardware

store. For your safety, it is strongly recommended that two people hang the lamp.

·Light bulb should be centered inside the pendant shade. Making sure it does not touch the shade.

·These instructions are provided for your safety. It is important that they are read carefully and completely before

assembling xture.

·This xture has been rated for up to (1) 60-watt maximum TYPE A standard light bulb (not included). To avoid the risk of

re, do not exceed the recommended wattage.

Warning:

·To reduce the risk of re, electrical shock or personal injury, always turn o lamp and allow it to cool prior to replacing light

bulb.

·Do not touch light bulb when xture is turned on.

·Keep ammable materials away from light bulb.

·THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR

WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

·Do not install on a radiant-heating ceiling.

Pre-assembly:

·Remove all parts and hardware from box along with any plastic protective

packaging.

·Do not discard any contents until after assembly is complete to avoid accidentally

discarding small parts or hardware.

·For your safety and convenience, assembly by two people is recommended.

·In order to use conversion kit, you must already have purchased a West Elm 3 wire

cordset with plug shown below:

wire nut connector 3x

mounting screw 2x

ground screw 1x

canopy screw 2x

Parts Enclosed:

• Mounting Plate (E)

• Cord Screw (I)

• Canopy (L)

Hardware Included:

• Wire Connector (A)

• Ground Screw (B)

• Canopy Screw (C)

• Mounting Screw (D)

ceiling junction box

Parts Enclosed

w/3-Wire Cordset :

• Socket (F)

• Socket Ring (G)

• Shade (H)

• Cable Stop (J)

• Cable Screw (K)

page 1 of 3

1772060/1742857

Tools needed:

Summary of content (3 pages)

PAGE 1
coconut strips pendant assembly instructions Important Safety Instructions: ·Joist mounting is recommended. Use proper hardware for your ceiling type. When in doubt consult your local hardware store. For your safety, it is strongly recommended that two people hang the lamp. ·Light bulb should be centered inside the pendant shade. Making sure it does not touch the shade. ·These instructions are provided for your safety. It is important that they are read carefully and completely before assembling fixture.
PAGE 2
coconut strips pendant assembly instructions Assembly: 1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER. 2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace. 3. Unscrew the plastic cord screw (I) from the canopy (L) using a small flate blade screwdriver. 4. Cut off the plug form the power cord and insert the wire into the canopy. Make sure to cut the cord and ground connector so that they are at least 6 inches long within the outlet box. 5.
PAGE 3
coconut strips pendant assembly instructions 11. Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL JUNCTION BOX WIRE. Fasten each together with a plastic wire nut connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed. 12. Connect the HOT FIXTURE WIRE to the HOT JUNCTION BOX WIRE ( black) or Clear. Fasten each together with a plastic wire nut connector (J) and wrap the connection with electrical tape. Be sure no wire strands are exposed.