Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Flat Stock Metal Single Sconce

page 1 of 2

assembly instructions

flat stock metal single sconce

9157967 - 01/07

To Assemble:

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.

2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace.

3. Carefully inspect the fixture wires. The NEUTRAL FIXTURE WIRE is white. The HOT FIXTURE

WIRE is black. The bare wire is the GROUND WIRE.

4. Attach the GROUND WIRE from the fixture to the GROUND JUNCTION BOX WIRE from the outlet (usually

green or bare wire). Fasten each together with a plastic wire connector (A) and wrap the connection with

electrical tape. Be sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE,

be sure to insert the green ground screw (B) into the mounting plate (J) as shown, and wrap the fixture's

bare ground wire around the ground screw. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

5. Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL JUNCTION BOX WIRE ( white). Fasten each together

with a plastic wire connector (A) and wrap the connection with electrical tape. Be sure no wire strands are

exposed.

Important Safety Instructions:

• These instructions are provided for your safety. It is important that they are read carefully and completely before

installing the sconce.

• We strongly recommend that a professional electrician install all direct wire fixtures.

• This fixture has been rated for up to (1) 60-watt TYPE B standard bulbs (not included). To avoid the risk of fire,

do not exceed the recommended wattage.

Pre-assembly:

• Remove all parts and hardware from box along with any plastic protective packaging. Do not discard any

contents until after assembly is complete to avoid accidentally discarding small parts or hardware.

• For your safety and convenience, assembly by two people is recommended.

Parts Enclosed:

• (1) Mounting plate (J)

• (1) Canopy (I)

• (1) Socket Ring (F)

• (1) Metal Tube (G)

• (1) Metal plate (K)

• (1) Glass Shade (H)

Hardware Included:

• Mounting screws (D)

• Green ground screw (B)

• Plastic wire connectors(A)

• Canopy screws (C)

• Wrench (E)

To install you will need:

• Electrical tape

• Screwdriver

wire cap 3x

grounding screw 1x

canopy screw 4x

mounting screw 2x

wrench 1x

Summary of content (2 pages)

PAGE 1
flat stock metal single sconce assembly instructions Important Safety Instructions: • These instructions are provided for your safety. It is important that they are read carefully and completely before installing the sconce. • We strongly recommend that a professional electrician install all direct wire fixtures. • This fixture has been rated for up to (1) 60-watt TYPE B standard bulbs (not included). To avoid the risk of fire, do not exceed the recommended wattage.
PAGE 2
flat stock metal single sconce assembly instructions 6. Connect the HOT FIXTURE WIRE to the HOT JUNCTION BOX WIRE ( black). Fasten each together with a plastic wire connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED. 7. Gently tuck the wire connections neatly into the ceiling junction box. 8.