Assembly Instruction

page 1 of 1

mounting instructions

6969810 - 06/06

: mirror framed mirror

NOTE:

• Stud mounting is recommended. Use proper hardware

for your wall type (such as anchors for drywall). When

in doubt, consult your local hardware store. For your

safety, installation by two people is recommended.

• This mirror can be mounted either way horizontally.

• Wipe with a soft, dry cloth. To protect the finish, avoid

the use of all chemicals and household cleaners.

2 2

drywall anchor 2x

screw 2x

1. Hold mirror at desired location. With a pencil, mark on wall the top

outside corners of the mirror. These marks will be used to determine

the location of the mounting hardware.

2. Measure down from the top of the mirror to the top of the keyhole

notches. Measure in from the side of the mirror to the top of the

keyhole notches. Record these measurements on the wall, using the

marks in step 1 as a guide. Align the two measurements until they

intersect. This is the insertion point of the mounting hardware. Use

a carpenter's level to ensure the mirror will be level.

3. For stud mounting: skip to step 4. For drywall mounting: using a

Philip's head screwdriver, insert the drywall anchors (A) into the

wall at the insertion points. Press and turn clockwise until anchors

are flush with the wall.

4. Insert screws (B) into the anchors or at the insertion points, leaving

approximately 1/2" between the back of the screw head and the wall.

5. Align keyhole notches over the screw heads.

6. Slide the mirror down until it rests on the screws. Tighten or loosen

screws as needed to fit the mirror snugly against the wall.

! For drywall mounting, use anchors with screws.

For stud mounting, use screws only.

3-5