$ ! ! ( ( / 1 " ! # ' " ! ! ! & + ! ! ! " ! # ! ! - ! ) & ! " # & # " ! & % " - & &
1. Place the Corner Seat up-side down. Attach the KD legs (3) into the bottom of seat. Align the hole on the leg into the corresponding holes on the seat frame (2), Insert bolt (A),Spring Washer (C), & Flat washer (D), at front & back, fully tighten with the allen key (F). As shown in the drawing. 1. Placez le coin de siège à l’envers. Fixer les pieds KD (3) dans le fond du siège.
2. Align back with seat frame as shown. Insert bolt (E). Tighten with supplied hex key (F). 2. Aligner retour avec l’armature du siège comme illustré. Insérez le boulon (E). Serrez avec la clé hexagonale fournie (F). 2. Alinear de nuevo con el marco del asiento como se indica. Inserte el perno (E). Apriete con la llave hexago nal suministrada (F). F E F E E F A B 3. Insert plate (B) into the top back of the seat back frames to hold them together. Insert bolt (A). Tighten with supplied hex key (F). 3.
. Align single unit with corner unit. Insert plate (B) into bottom of both units. Insert bolts (A), tighten with supplied hex key. Align sofa unit with corner unit nsert bolts (A), tighten with supplied hex key (F). 4. Aligner seule unité avec l’unité de coin. Insérez la plaque (B) dans le fond des deux unités. Insérez les bou lons (A), serrer avec la clé hexagonale fournie. Aligner l’unité canapé avec des boulons coin unité nsert (A), serrer avec la clé hexagonale fournie (F). 4.