Assembly Instruction

mounting instructions

: open wall cube

4531000/4793378/7077233/7076409 - 03/05 page 1 of 1

drywall anchor 2x

screw 2x

NOTE:

• Stud mounting is recommended. Use proper hardware

for your wall type (such as anchors for drywall). When

in doubt, consult your local hardware store. For your

safety, installation by two people is recommended.

• This shelf can be mounted either way horizontally.

• Designed to be used for decorative items only.

• Maximum load on shelf is 20 lbs.

• Wipe with a soft, dry cloth. To protect the nish, avoid

the use of all chemicals and household cleaners.

2 2

1. Hold shelf at desired location. With a pencil, mark on wall the top

outside corners of the shelf. These marks will be used to determine

the location of the mounting hardware.

2. Measure down from the top of the shelf to the top of the keyhole

notches. Measure in from the side of the shelf to the top of the

keyhole notches. Record these measurements on the wall, using the

marks in step 1 as a guide. Align the two measurements until they

intersect. This is the insertion point of the mounting hardware. Use

a carpenter's level to ensure the shelf will be level.

3. For stud mounting: skip to step 4. For drywall mounting: using a

Philip's head screwdriver, insert the drywall anchors (A) into the

wall at the insertion points. Press and turn clockwise until anchors

are ush with the wall.

4. Insert screws (B) into the anchors or at the insertion points, leaving

approximately 1/2" between the back of the screw head and the wall.

5. Align keyhole notches over the screw heads.

6. Slide the shelf down until it rests on the screws. Tighten or loosen

screws as needed to t the shelf snugly against the wall.

! For drywall mounting, use anchors with screws.

For stud mounting, use screws only.

3-5