Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Parsons Door Unit

parsons door unit

assembly instructions

Page 1 of 79285255 - 01/02/09

! Tools required:

! Do not throw away packaging materials until assembly is complete.

! Assemble this item on a soft surface, such as cardboard or carpet, to protect ﬁ nish.

! Proper assembly of this item requires 2 people.

bolts 6mm x 30mm 12x

Hardware

ﬂ at washer 12x

lock washer 12x

plastic clasp 4x

screw 4x

shelf pin 8x

Mounting Plate 2x

Nylon Strap 1x

Small Screw 2x Large Screw 2x

Anti tip kit 1x

Summary of content (7 pages)

PAGE 1
parsons door unit assembly instructions ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. ! Proper assembly of this item requires 2 people.
PAGE 2
parsons door unit assembly instructions 1. Align bottom with sides . Insert bolt (A), lock washer (C), and flat washer (B). Tighten with supplied hex key. Do not overtighten.
PAGE 3
parsons door unit assembly instructions 2. Align Legs with bottom. Insert bolt (A), lock washer (C), and flat washer (B). Tighten with supplied hex key. Do not overtighten.
PAGE 4
parsons door unit assembly instructions 3. Stand unit upright. Slide back panel into groove in sides. 4. Align top with sides . Insert bolt (A), lock washer (C), and flat washer (B). Tighten with supplied hex key. Do not overtighten.
PAGE 5
parsons door unit assembly instructions 5. Press plastic clasps into grooves on back of unit like drawing shows. Insert screws into claps. Tighten with screwdriver.
PAGE 6
parsons door unit assembly instructions 6. Align door with hinges on side . Slide door onto hinges. Making sure they snap into place. 7. Insert shelf pins into sides at desired locations. Carefully slide shelves into unit. Make sure pins are firmly pressed into place.
PAGE 7
parsons door unit assembly instructions NOTICE: To prevent injury and property damage from unexpected tipping of furniture, we highly recommend installation of the anti-tip kit included with this product. Attaching unit to wall with anti-tip kits. 1. Determine where the unit is to be placed and mark location on the wall for the mounting bracket screw holes. They should be placed approximatly 1” below the top on the back of the unit. 2.