Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Sliding Door Media Stand

sliding door media stand

assembly instructions

Page 1 of 55946165/5946173 - 03.03.08

! Tools required:

! Do not throw away packaging materials until assembly is complete.

! Assemble this item on a soft surface, such as cardboard or carpet, to protect ﬁ nish.

! Proper assembly of this item requires 2 people.

cam bolt 12x Cam lock12x

dowel 12x shelf support 8x

short screw 18x

Hardware

Summary of content (5 pages)

PAGE 1
sliding door media stand assembly instructions ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. ! Proper assembly of this item requires 2 people. Hardware A B cam bolt 12x C Cam lock12x D dowel 12x shelf support 8x E short screw 18x 5946165/5946173 - 03.03.
PAGE 2
sliding door media stand assembly instructions 1. Lay the bottom of the media stand on a soft surface. Insert 6 dowels (C) into holes as drawing shows. Using a phillips head screwdriver screw the cam bolts (A) into the bottom panel. Insert cam locks (B) into the end panels and the partition like the drawing shows. Slide the end panels and partitions down over the dowels and cam bolts. Tighten cam locks with phillips head screwdriver. End panel Partition End panel A C B 2.
PAGE 3
sliding door media stand assembly instructions 3. Center back screen onto back of media stand and screw in 18 screws (E) through back screen into media unit using a phillips head screwdriver. 4. Insert 8 shelf support (D) into end panels and partition to support the shelves. Make sure that the supports are level and that the shelf sits flat. 5946165/5946173 - 03.03.
PAGE 4
sliding door media stand assembly instructions 5. Align bottom of sliding door into track in bottom panel, making sure that the top door lock is down. Stand door upright against the top panel. Slide door lock up making sure that it latches into the groove in the bottom of the top panel. Slide door into place at angle, aligning bottom guide into track Then stand the door up into place Top lock in down position Top lock in up (Locked) position Door locks Track in bottom panel 5946165/5946173 - 03.03.
PAGE 5
sliding door media stand assembly instructions ! CAUTION The top shelf of this stand is intended for use with: Plasma/LCD Televisions having a maximum screen size of 52” and a weight of 135 lbs. Tube televisions having a maximum screen size of 30” and weight of 135 lbs. CARE INSTRUCTIONS Hardware may loosen overtime. Periodically check that all connections are tight. Wipe with a soft, dry cloth. To protect finish, avoid the use of chemicals and household cleaners. 5946165/5946173 - 03.03.