Assembly Instruction

ManualsBrandsWest Elm ManualsAccessoriesWest Elm Stripe Bowl Pendant

Important Safety Instructions:

·Stud mounting is recommended. Use proper hardware for your wall type. When in doubt consult your local hardware

store. For your safety, it is strongly recommended that two people hang the lamp.

·Electric bulb should be centered inside the pendant shade, making sure it does not touch the outer sides.

·These instructions are provided for your safety. It is important that they are read carefully and completely before

assembling xture.

·This xture has been rated for up to (1) 100-watt maximum TYPE A standard bulb (not included). To avoid the risk of

re, do not exceed the recommended wattage.

assembly instructions

page 1 of 2

Warning:

·To reduce the risk of re, electrical shock or personal injury, always turn o

and unplug lamp and allow it to cool prior to replacing light bulb.

·Do not touch bulb when xture is turned on. Do not look directly at lit bulb.

·Keep ammable materials away from lit bulb.

Pre-assembly:

·Remove all parts and hardware from box along with any plastic protective packaging.

·Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.

·For your safety and convenience, assembly by two people is recommended

Parts Enclosed:

• (1) Mounting plate (E)

• (1) Canopy (F)

• (1) Lamp Socket (G)

• (1) Socket Ring (J)

• (1) Glass Shade(I)

Hardware Included:

• (1) Mounting screws (C)

• (2) Green ground screws (B)

• (3) Plastic wire caps (A)

• (4) Canopy screws ( D )

To install you will need:

• Electrical tape

• Screwdriver

stripe bowl pendant

5662127 - 03/08

grounding screw

canopy screws

mounting screws 1x

wire caps 3x

To Assemble:

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE

BOX/CIRCUIT BREAKER.

2. Carefully unpack all xture parts and hardware and lay out on a clear

workspace.

3. Take the Glass Shade (I)onto the lamp Socket (G)

4. Screw the Metal Ring (J) onto the lamp Socket (G)

5. Carefully inspect the chandelier's xture wires. The NEUTRAL FIXTURE

WIRE is white or marked “N”. The HOT FIXTURE WIRE is black or marked “L”.

The yellow-green or bare wire is the GROUND WIRE.

Summary of content (2 pages)

PAGE 1
stripe bowl pendant assembly instructions Important Safety Instructions: ·Stud mounting is recommended. Use proper hardware for your wall type. When in doubt consult your local hardware store. For your safety, it is strongly recommended that two people hang the lamp. ·Electric bulb should be centered inside the pendant shade, making sure it does not touch the outer sides. ·These instructions are provided for your safety. It is important that they are read carefully and completely before assembling fixture.
PAGE 2
stripe bowl pendant assembly instructions 6. Attach the GROUND WIRE from the fixture to the GROUND JUNCTION BOX WIRE from the outlet (usually green or bare wire). Fasten each together with a plastic wire connector (A) and wrap the connection with electrical tape. Be sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE, be sure to insert the green ground screw (B) into the mounting plate (E) facing DOWN, and wrap the fixture's bare ground wire around the ground screw.