wine bar assembly instructions 5662218 - 2/27/08 Page 1 of 10
wine bar assembly instructions ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. ! Proper assembly of this item requires 2 people.
wine bar assembly instructions 1. Using phillpis head screwdriver, insert and tighten cam bolts (I) into threaded insert in the bottom of each end panel. There will be 2 cam bolts (I) in each end panel. Next insert 2 dowels (M) into each end panel. DO NOT OVERTIGHTEN CAM BOLTS! End panel Partition Threaded inserts Dowel End panel Cam Bolt 2. Locate the 4 holes in the bottom of the bottom panel. Insert a cam lock (J) into each hole like the drawing shows.
wine bar assembly instructions 3. Align the cam bolts (I) in the end panels with the holes in the side of the bottom panel to so they will come in contact with the cam locks (J). Next slide the end panel against the bottom panel and using the phillips head screwdriver tighten the cam locks clockwise 1/2 turn. Next slide other end panel against bottom panel and tighten cam locks (J) clockwise 1/2 turn. End panel Partition Bottom panel End panel 4.
wine bar assembly instructions 5. Insert Bolts (A) assembled with Lock washer (C) and Metal Metal washer (B) into the 4 holes on the bottom frame that line up with the bottom panel. Tighten these bolts with the supplied Allen key (D) clockwise until tight. Do not overtighten! After attaching the base frame you will need to stand case upright to finish assembly. Bottom Frame 6. Locate back panel grooves in the end panels and bottom panel. Slide back panels down into this groove.
wine bar assembly instructions 7. Place top panel onto top of bar and align bolt holes with the holes in the end panels and partitions. Insert 6 bolts with washers into the six holes indicated on the drawing. Tighten with the supplied allen key (D).
wine bar assembly instructions 8. You will need to secure the back panel into place with the plastic clasps (K). Insert a screw (L) into each clasp (K) . From the back of the bar insert the clasp into the groove in the end panels, bottom panels and top frame. You may need to lightly push the back panel towards the front of the bar to open the gap for the clasp to slide into.
wine bar assembly instructions Hinge brackets 9. Locate Hinge brackets on end panel and align the door with them. Next slide the door hinges over the brackets until they click. Make sure that both hinges are secure. Door Shelf pin holes Door 10. Insert 4 shelf pins (G)as shown into the holes in the end panel and 4 shelf pins (G) in the partition, making sure they line up across from each other. Lay 1 shelf on each set of 4 shelf pins (G). 11.
wine bar 12. Align tray and gently place it on top of the bar. assembly instructions 13. Locate the small holes in the partition, end panel, top frame and shelf used for the magic wire shelf guide. Insert 4 magic wires (H) into these holes in the Partition, End panel, top frame and the shelf. Press firmly so that they insert completely. Next line up the “t” shaped partition with grooves with the magic wire and slide the “t” partition into place.
wine bar assembly instructions NOTICE: To prevent injury and property damage from unexpected tipping of furniture, we highly recommend installation of the anti-tip kit included with this product. Attaching wine bar to wall with anti-tip kit. 1. Determine where the wine bar is to be placed and mark location on the wall for the mounting bracket screw holes. They should be placed approximatly 2” below the top on the back of the wine bar. 2.
