Installation Guide

Options
Shower arm range
Fixed head arms
Important information
This product must be installed by a competent person in accordance with the relevant current
Water Supply Regulations.
The Aqualisa Options range of accessories are supplied complete with a 2 year guarantee.
In the event of any product problems, please contact the Aqualisa Customer Helpline on
01959 560010.
!
Aqualisa Products Limited, The Flyer’s Way, Westerham, Kent TN16 1DE
Customer Helpline: 01959 560010 Facsimile: 01959 560030
Website: www.aqualisa.co.uk E-mail: [e-mail]
2
If using the ½” nipple provided, ensure the thread is clean and
free of dust and apply sealing tape as required. Fix the nipple
into place and secure using a 10mm hexagonal key.
3
Run a 15mm outlet pipe from the valve, diverter or processor to the preferred position for the
fixed head arm. The pipe must terminate with a suitable ½” BSP fitting.
Apply sealing tape to the exposed ½” BSP male thread and
secure the fixing arm into place ensuring the arm is correctly
aligned.
4
The wall mount fixed arm is supplied factory fitted with ½”
BSP male thread intended to be secured to a suitable ½” BSP
female fitting. Using a 10mm hexagonal key remove the ½”
nipple from the fixing arm.
1
If required, the fixing arm may be fitted directly to a suitable
½ “BSP male fitting.
!
Ceiling mounted
Run a 15mm outlet pipe from the valve, diverter or processor to the preferred position for the fixed
head arm. The pipe must terminate with a suitable ½” BSP fitting.
2
If using the ½” nipple provided, ensure the thread is clean and
free of dust and apply sealing tape as required. Fix the nipple
into place and secure using a 10mm hexagonal key.
3
Apply sealing tape to the exposed ½” BSP male thread and
secure the fixing arm into place ensuring the arm is correctly
aligned.
4
Apply a thin bead of mastic to the rear of the cover plate and
place into position flush with the finished ceiling surface.
6
The ceiling mount fixed arm is supplied factory fitted with ½” BSP
male thread intended to be secured to a suitable ½” BSP female
fitting. Using a 10mm hexagonal key remove the ½” nipple from
the fixing arm.
1
If required, the fixing arm may be fitted directly to a suitable
½ “BSP male fitting.
!
Temporarily cap off the end of the shower arm and turn on the shower to pressurise the system
and check for leaks. If all is sound, turn the shower off and remove the blanking cap
(remembering the system may be under pressure).
5
Apply a thin bead of mastic to the rear of the cover plate and
place into position flush with the finished wall surface.
6
Temporarily cap off the end of the shower arm and turn on the shower to pressurise the system
and check for leaks. If all is sound, turn the shower off and remove the blanking cap (remembering
the system may be under pressure).
5
Part No:700399 Issue 01 Jun 12
Wall mounted