Product Installation Manual FCC ID : 2AUPS-W1XXX 2019 WESTCHARGE PRIVATE LIMITED CONFIDENTIAL
Instruction and Installation manual for On the Desk Wireless Charger THIS DOCUMENT IS FOR USE ONLY BY ORIGINAL EQUIPMENT MANUFACTURERS (OEMS), OEM DEALERS OR INSTALLATION SERVICE FIRMS (TOGETHER INSTALLERS) WHO PURCHASE THE REFERENCED WESTCHARGE COMPONENTS FROM WESTCHARGE PRIVATE LIMITED Components 1. Wireless charger (transmitter) 2.
. Power adapter to power the IOT device & Wireless charge (Transmitter). 4. 30 cm long, 6 wired connector cable to connect the charger with the IOT device.
5. Packing blade (L: 100mmx B:20mm x H:1.58mm) 6.
7. One Allen Key. 8. Two 12‐20 mm M3 wood screws to fasten the packing blade to the table.
9. Cable clips.
Installation Guide 1. Drill out a 60 mm hole in the table, where the charger has to be fixed. 2. Place the charger unit into the hole.
3. Pass the screw with the nut attached through the central hole of the packing blade.
4. Place the packing blade under the table, exactly below the charger and tighten the screw to the charger unit. 5. Fix the wooden screw ends of packing blade.
6. Plug in the 6 wired connector cable from the charger unit into the IOT device. 7. Connect the power adapter to the IOT device and plug it in to the main supply.
These are the Authorised model numbers W1SU, W1SOG, W1SOB, W1SOC, W1FU, W1FOG, W1FOB, W1FOC 2019 WESTCHARGE PRIVATE LIMITED CONFIDENTIAL
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: [1] This device may not cause harmful interference and [2] This device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to the equipment. Such modifications could void the user’s authority to operate the equipment.
