User's Manual

WS-2100/4100 Operating Manual

3.5 How to Use Analog G3 Fax

Terminals with the Analog G3 Fax Board can send and receive documents with Fax machine. Fax

Board is an optional item. To use Fax function, Fax machine should be connected with terminal.

3.5.1 To Send a Document by Fax

Pick up the Fax handset and make sure there is a dial tone then press *00 and then dial the

number you want to send the Fax on Fax machine and follow the instructions of the Fax machine

connected to the terminal.

3.5.2 To Receive a Document by Fax

You need to set the Terminal to Receiving Mode to receive documents through the Analog G3 fax

using this terminal. Pick up the Fax handset and press ###005 to set the terminal to Receiving

Mode of Analog G3 fax. An incoming Fax message will be received by Fax machine connected to

the terminal.

[Note] Once the terminal is set to the Analog G3 Fax Receiving Mode, you can not receive

regular incoming calls. To go back to normal mode after receiving Fax, press ###000 to release

Fax Receiving Mode.

3.6 Data Service

Using RS-232 Data Cable, you can connect this terminal to PC for Internet, PC Communication

and/or PC Fax communication, if your service provider provides Wireless Data Communication

Service.

3.6.1 Setting Data Service Receiving Mode

There are several options for Data Service Receiving Mode as follows;

• PC Modem Receiving, One Time Mode; After one connection and/or after 10 minutes, the

setting will be automatically released and terminal will be changed to Normal Phone mode.

• PC Modem Receiving, Always Mode: The terminal will remain at this mode until you

changed the mode or the power is turned off.

• PC Fax Receiving, One Timer Mode; After one connection and/or after 10 minutes, the

setting will be automatically released and the terminal will be changed to Normal Phone

mode.

• PC Fax Receiving, Always Mode; The terminal will remain at this mode until you change the

mode or the power is turned off.

[Note]

While terminal is at Data Service Receiving mode, you can not make or receive calls, so after

using Data Receiving service, you have to change the mode to Normal Phone mode, by pressing

###000.