User's Manual

WS-2100/4100 Operating Manual

4.4.1 Outgoing Lock

The Outgoing Lock function is used to block other people from using the terminal.

If you make a call while this function is on, the terminal generates an error sound indicates that

making a call is not possible. This function only prevents outgoing calls. Receiving a call is still

possible while the Outgoing Lock function is turned on.

To use the phone, you need to unlock the phone by entering your password.

The Default setting is <Outgoing Lock off>.

4.4.1.1 Turning the Outgoing Lock On / Off

① Enter #0*100 à 4

② Enter your four digit password.

[Note] If you enter an incorrect password, the Reject Tone will sound and you need to re-enter the

password.

③ Press <1> button to enable this function and <2> to reset this function.

④ Press <*> button to terminate this function.

#0*100 à 4 à password à 1 à * : Lock function On

#0*100 à 4 à password à 2 à * : Lock function Off

4.4.2 Changing Lock Code (User’s Password)

① Enter #0*100 à 4 to change your password.

② Press <3> after entering a password in use.

③ Enter the new password and press * button.

④ Enter the new password again and press * button.. The new password has been activated.

#0*100à4àpasswordà 3ànew passwordà * ànew passwordà * : password change

[ Note ]

The Default password is 0000

4.4.3 Reset as Default

This function is used to change the main settings of the terminal back to the default settings, which

were programmed into the terminal at the factory.