User Manual

Installation and Operator Handbook Programming and Configuration
AMX-MA-00657 Issue: 1.02 (USA) Page 5
The DMR-25 Programmer is now ready to read or write data to or from the DMR-25 module.
5.2.6 Getting Help
The information contained in this manual is available as on-line help as part of the DMR-25 Programmer.
To get help on the DMR-25 Programmer, from the main menu click on the Help pull-down menu and
select Contents, Search or Index as required.
5.2.7 Running the DMR-25 Programmer
There are many configuration options available to the user, some of which depend on the hardware options
installed. Other parameters are operational such as the desired receive and transmit operating frequency
and channel number.
Once the DMR-25 Programmer is installed, the Main Screen provides access to the following dialog boxes:
• File: Generate a New file, Open an existing file, Save, and Save As. Other options allow
the user to Print, Get and Send data.
• Configure: Serial Comms for selection of Serial Port, Modem Commands and Exit Binary
Mode. See Section 3, Configuring Communications.
• Program: Allows user to edit DMR-25 transceiver data using Radio Wide Settings, Channel
Table, Tone Remote Settings, Encryption Settings, Squelch Groups, License Features and
Change Password.
• Phone: Gives the user the ability to dial up over a modem to connect to the Transceiver, and
also hang up when the programming is complete.
• Help: Supplies user with on-line help documentation through Contents, Search,
Using Help and About DMR-25 Programmer.
Initial or existing configuration data can be obtained in the following ways:
• File | Open: opens a previously saved file (Will prompt user to save before overwriting currently
opened file).
• File | Get: gets the current file from a DMR-25 Transceiver Module (Will prompt user to save
before overwriting open file).
• File | New: creates a new file via user input dialog boxes.
It is possible to send DMR-25 Transceiver data to the transceiver module by using the File | Send option.
Note that the DMR-25 programmer will reboot the transceiver module after sending the programming
information in order to invoke the new configuration.