User Manual

Installation and Operator Handbook Programming and Configuration
AMX-MA-00657 Issue: 1.02 (USA) Page 8
5.3.2 Modem Communications
Consult your modem manual to determine what it requires for initialisation string, dial string, and hangup
string. To set the modem commands used by the DMR-25 Programmer, select the Configure pull-down
menu and select Modem Commands. The Modem Commands dialog box will appear as shown in
Figure 5-3.
Init: The modem initialisation string stores parameters to configure the modem after power up.
Dial: The modem command required before dialing a number.
Hangup: The command required to hangup the modem.
Figure 5-3 Modem Commands Dialog Box
5.3.3 Exit Binary Mode
Configure/Exit Binary Mode: When issuing a File/Send or File/Get command, the PC to DMR-25
communication mechanism on the DMR uses a binary mode. On a failed File/Send or File/Get order, the
DMR may be left in binary mode. The Configure/Exit Binary Mode menu item will, when selected,
force
the DMR back into normal operating mode.