User Manual
Table Of Contents
- 3 INSTALLATION INSTRUCTIONS
- 3.1 GENERAL
- 3.2 SAFETY PRECAUTIONS
- 3.3 SITE REQUIREMENTS
- 3.4 DELIVERY AND UNPACKING
- 3.5 INSTALLATION
- 3.6 CONNECTIONS
- 3.6.1 Grounding Strap
- 3.6.2 AC Power
- 3.6.3 DC Power
- 3.6.4 Antenna Cabling
- 3.6.5 External Interfaces
- 3.6.5.1 Transceiver Module Audio Connector
- 3.6.5.2 Transceiver Module Programming Connector
- 3.6.5.3 Controller Module Serial Data Connector
- 3.6.5.4 Radio Serial Data
- 3.6.5.5 Analog Line Connection
- 3.6.5.6 RS-485 serial data
- 3.6.5.7 Ethernet
- 3.6.5.8 General Purpose Input/Output Lines
- 3.6.5.9 External 10 MHz reference source
- 3.6.5.10 Standby power
- 3.6.5.11 -48 V DC input
Installation and Operator Handbook Installation Instructions
AMX–MA–00653 Issue 0.02 (USA) 13
3.6.5.2 Transceiver Module Programming Connector
Function: Connects programming PC to Transceiver Module
Located: Transceiver Module front panel (upper connector)
Electrical: RS-232
Connector: RJ11
Pin allocation: (Pin 1 is the top pin looking from the front of the module)
Pin Function
1 N/C
2 Reserved
3 Transmit data (output)
4 Receive data (input)
5 Ground
6 N/C
3.6.5.3 Controller Module Serial Data Connector
Function: Connects Diagnostic PC to DRB-25
Located: Controller Module front panel
Electrical: RS-232
Connector: RJ11
Pin allocation: (Pin 1 is the top pin looking from the front of the module)
Pin Function
1 RTS (outpuyt)
2 CD (input)
3 Transmit data (output)
4 Receive data (input)
5 Ground
6 CTS (input)
3.6.5.4 Radio Serial Data
Function: APCO Project 25 Data Host Interface (Ed) for circuit switched data
Status: Future enhancement, software upgrade
Located: Interface Module
Label: Serial One, Serial Two (one per transceiver module)
Electrical: RS-232
Connector: DB9 (female)