User Manual

Installation and Operator Handbook DRB-25 Diagnostics Monitor
AMX-MA-00656 Issue 0.02 (USA) 6
Parameter Range/Description Default
Data Bits 7 to 10 8
Parity Odd, Even, None. O
Stop bits 1, 1.5, 2 1
6.3.3 Configure Polling Interval
The Configure | Polling Interval dialog box enables the user to set the interval at which the DRB-25
Diagnostic Monitor polls the Controller card for status information. The default polling interval is 1000ms.
The Polling Interval Dialog box will appear as shown in Figure 6-3.
Figure 6-3 Polling Interval Dialog Box
To enter/change parameters:
1. Place the cursor in the cell
2. Delete the existing value in the cell and enter the new parameter.
3. Click OK to update the current configuration.
OK
Closes the Polling Interval dialog box and writes any newly-entered communications data to the ZDM
application’s .INI file.
Cancel
Closes the Polling Interval dialog box without writing data to the .INI file..
Help
Provides access to on-line help on the Polling Interval dialog box.
6.3.4 Status/Test
From the Main Menu the Status/Test gives access to the status dialog boxes for Radio 1, Radio 2 and Alarms
and the test dialog boxes for Radio 1, Radio 2. It also includes provision to change the password used to
access the test functions.