User Manual

Installation and Operator Handbook Programming and Configuration
AMX-MA-00657 Issue: 1.02 (USA) Page 4 of 25
4. Run Windows Explorer, and with it display the contents of the CD drive or floppy drive in which the
installation media is located.
5. Double-click on the file “setup.exe” to commence the installation. If there are multiple disk images on
the CD, it will be located in the directory labeled “Disk1”. On a floppy it will be a top-level file.
6. Follow the instructions given by the Setup dialog boxes.
If installation problems occur, contact the supplier.
5.2.4 Starting DMR-25 Programmer for the First Time
To start the DMR-25 Programmer, select the DMR-25 Programmer icon from the Start | Programs menu.
The DMR-25 Programmer main window will appear as shown in Figure 5-1.
Figure 5-1 DMR-25 Programmer Main Window
5.2.5 Connecting the Programmer to the Transceiver Module
To connect to a DMR Transceiver module:
1. A programming cable (Westel Part number CB-02272) is required. Connect the PC communications
port to be used to the required DMR-25 Transceiver Module RJ-11 serial port connector using the
programming cable.
2. Using the procedure given in Section 3.1, Serial Communications, set the PC communications port used
to connect to the DMR.