Instruction manual

21
Click the Define Customer Service button to
move to the next page
Put a dot in the Port Forwarding Ranges of
Ports radial button. Then click next at the
bottom of this page
Enter a name for the program or device you are
forwarding ports for in the Service Name box. Ex :
DVR
Enter the ports to forward into the Global Port
Range boxes.
Example: for port 2000-2000
The smallest port number should go into the box on
the left, while the largest port number should go
into the box on the right.
Main port the program uses into the Base Port
box. This is your lower port from your list.
Examples: If you are using only one port like
2000 enter 2000-2000.. If your are using a
range of port like 80-1080, the base port is 80
Select the protocol type using the UDP or TCP
radial buttons.
Click the Next button when you are done
making changes.
If you need to add additional ports, click the Add
button.
When you are done adding ports/protocol types,
click the Close button
Continue on Next page….