User's Manual Part 2

TriLink Gateway – Draft 5

030-300445 Rev. A

6/22/05

030-300445 Rev. A 70 June 2005

User Guide

TriLink Gateway (Models 427V10, 427V11)

17.5 LAN Configuration

17.5.1 DHCP

The following screen will be displayed if you select LAN > DHCP from the Configuration menu. This page enables

you to control how the Router interacts with local devices to which it is connected. Enter the appropriate values, and

then click Save to save your settings.

Note: Westell recommends that you do not change these settings unless instructed by your Internet service provider.

DHCP Configuration for Private LAN

Enable DHCP Server Factory Default = Enable

This setting allows the Router to automatically assign IP addresses to local devices

connected on the LAN. Westell advises setting this to enabled for the private LAN.

Private LAN = DHCP addresses will be saved into the Private LAN configuration.

Public LAN = DHCP addresses will be saved into the Public LAN configuration. (This

option is only available if the Public LAN DHCP server is enabled.)

Possible Response:

If this box is checked, the DHCP server will be turned On.

If this box is unchecked, the DHCP server will be turned Off.

NOTE: These addresses will be overwritten if the Internet Service Provider supports

dynamic setting of these values.

Modem IP Address The IP Address of the Router

Subnet Mask The Subnet Mask of the Router

Address Range

DHCP Start Address Factory Default = 192.168.1.10

This field dis

s the first IP address that the DHCP server will

rovide. The DHCP