User's Manual Part 2

TriLink Gateway – Draft 5
030-300445 Rev. A
6/22/05
030-300445 Rev. A 71 June 2005
User Guide
TriLink Gateway (Models 427V10, 427V11)
Start Address must be within the IP address and lower than the DHCP End Address.
You may use any number from 0 to 254 in this address.
DHCP End Address Factory Default = 192.168.1.20
This field displays the last IP address that the DHCP server will provide. The DHCP
End Address must be within the IP address and higher than the DHCP Start Address.
You may use any number from 0 to 254 in this address.
DHCP Lease Time Factory Default = 01:00:00:00
Displays the amount of time the provided addresses will be valid, after which the
DHCP client will usually re-submit a request.
NOTE: DHCP Lease Time is displayed in the format (day:hour:min:sec)*. This value
must be greater than 10 seconds. Seconds must be between 0 and 59, minutes must be
between 0 and 59, and hours must be between 0 and 23.
17.5.2 DNS
The following screen will be displayed if you select LAN > DNS from the Configuration menu.
DNS
Domain Name
NOTE: Some ISP’s may require the
name for identification purposes.
This field allows you to enter a Domain Name for the Router.
To add a Domain Name, in the field under User Assigned DNS, type in
your new domain name and click Set.
Static Host Assignment
Host Name This field allows you to enter a HOST name for the Router.
To add a new Host name, in the field under Static Host Assignment, type
in the Host Name and the associated IP address and then click Add.
To delete a Host name, click the Delete button adjacent to the Host Name
and IP Address you want to delete.