User's Manual Part 2

TriLink Gateway – Draft 5
030-300445 Rev. A
6/22/05
030-300445 Rev. A 87 June 2005
User Guide
TriLink Gateway (Models 427V10, 427V11)
17.7.5 VCs
The following screen will be displayed if you select WAN > VCs from the Configuration screen.
NOTE: In order to enable or edit the VCs, first confirm that your Router is configured for ‘Private LAN’. To
configure your Router for Private LAN, return to the VersaPort screen and select Private LAN. Next, click Save to
save your settings.
The Edit button enables you to change the VC configuration settings of the Router. Details on the edit button are
explained later in this section.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
Status Allows you to enable or disable your VC (Virtual Connection)
VPI
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
VCI
Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.
Protocol
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you.
Displays the Protocol for each VC, which is specified by your Service
Provider.
Possible Response:
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Routed IP = IP over ATM